Copper Spur UL1 Bikepack Footprint: Fit and Setup Guide

By Sleeping Bags, Tents, Pads & Outdoor Gear | Published: 2026-11-01

Category: How-to Guides

Learn how to attach and pitch the Copper Spur UL1 Bikepack footprint correctly, including Fast Fly setup and common fit mistakes to avoid.

Quick answer

Attach the Copper Spur UL1 Bikepack footprint by matching its corners to the tent floor before staking, then clip the tent body or fly to the same stake points. For Fast Fly, use the footprint, fly, poles, and stakes without the tent body.

Why the correct footprint matters for bikepacking

A footprint adds a sacrificial layer between your tent floor and abrasive ground, which is especially useful on bikepacking trips where campsites may be rocky or rooty. The Copper Spur UL1 Bikepack footprint is shaped for that tent, so a generic footprint may not align with stake points or door orientation.

Using the wrong footprint can leave exposed floor areas or create a loose fit that collects water. The catalog confirms compatibility with both the Copper Spur UL1 Bikepack and the Copper Spur UL1, so check your tent model before ordering.

Fast Fly setup: when to leave the tent body behind

The footprint enables a Fast Fly shelter using the footprint, tent fly, poles, and stakes. This configuration saves weight and packed volume on trips where bug protection is less critical, but it is not a substitute for a full tent body in wet or insect-heavy conditions.

Fast Fly requires all four components; omitting the footprint means no floor protection and an incomplete shelter. Practice this setup at home before relying on it in the field.

Step-by-step footprint setup

Match footprint corners to tent floor: Lay the footprint flat and align each corner with the corresponding corner of the tent floor. The footprint should not extend beyond the floor edges. Check that no footprint corner is twisted or inverted before staking.
Stake the footprint corners: Stake the footprint at its corner loops, keeping the fabric taut but not stretched. Use the same stake points you will use for the tent body or fly. Avoid driving stakes through the footprint fabric; use the designated loops.
Attach tent body or fly: Clip or stake the tent body to the same stake points, or for Fast Fly, attach the fly to the poles and stake it over the footprint. Confirm the fly overhangs the footprint evenly on all sides.
Adjust tension and check coverage: Fine-tune stake positions so the footprint stays centered under the tent floor. The footprint should be fully covered by the tent floor or fly. If any footprint edge is exposed, reposition stakes before tensioning further.
Pack and care for the footprint: Shake off debris and fold or roll the footprint separately from the tent to avoid abrasion. Store dry and avoid prolonged compression. A dry footprint prevents mildew and extends the life of the waterproof coating.

Product facts

Copper Spur UL1 Bikepack Footprint: Compatible with the Copper Spur UL1 Bikepack and the Copper Spur UL1. Confirms fit for both tent versions so you can order with confidence.
Copper Spur UL1 Bikepack Footprint
Copper Spur UL1 Bikepack Footprint: Enables a Fast Fly shelter when used with the tent fly, poles, and stakes. Lets you pitch a lighter setup without the tent body when conditions allow.